Shift Lever M

lbm · Feb 1, 2010

Anyone know the dimesions of the tip of gear shift lever where it rides in the shift rail, before I start building it up.

Thanks

Nebraska Cowman · Feb 2, 2010

trial and error. If you get it too big it will bind. just grind more off. Here is what it should look like.

GordoSD · Feb 2, 2010

Check archives. Someone posted a great engineering sheet on them not too long ago. Nenlinc I think.

Gordo

neblinc · Feb 2, 2010

Here ya go.

Randy

sflem849 · Feb 2, 2010

(quoted from post at 12:18:35 02/02/10) Here ya go.

Randy

This is the one I used for my H and it worked just fine. I ground it lightly then we TIG welded the material back on. We could lay it a lot smoother and slower with the TIG welder.
You can go to Farm Country or Pilot Knob and get the rebuild stuff for the swivel thingy. They usually get a little sloppy as well.

GordoSD · Feb 2, 2010

Are the H, SH, M SM all the same?

Gordo

Lew in UT · Feb 2, 2010

this is a problem with all the older tractors and especially old agzeler transmissions in trucks some will disagree. but hear go's if you are a bit good with acetylene torch take a electric chromium type hard surfacing rod brake the flukes of the out side ,
grind the Warren part and grind it slightly whear it is worn to clean it up,then take the torch and build the wrong places up with the chromium hard rod, then grind to the same size as the rest of the lever that has not worn the sides are all that you need to be concerned about. you will never have to worry about it agen.

Shift Lever M

lbm

Member

Nebraska Cowman

Well-known Member

GordoSD

Well-known Member

neblinc

Member

sflem849

Well-known Member

GordoSD

Well-known Member

Lew in UT

New User

Similar threads