installing a wide front on a farmasll H

Robert Fallot · Jan 29, 2010

Is there a schematic or manual available that would show what is required to remove the narrow front and install the wide front

jason r · Jan 29, 2010

Parts book would be the best place to start if you are dealing with a factory WF

Vito · Jan 29, 2010

Not hard to do at all.Common sense will show you how.

Vito

Deano4863 · Jan 29, 2010

I just got done installing an original IH WFE on an H. Everything was self evident what had to happen. All bolt holes matched up. I did have to drill 3-1/2" holes in the frame rails. Very easy as I bolted up the WFE and used it as a guide to drill. I did it by myself using the pallet forks on my loader to hold and position it. Only took me about an hour not including the trip to the hardware store for bolts.

ih560 · Jan 30, 2010

It's just as stated above, this is a very simple procedure. The only part that makes it difficult is that it weighs a good bit and some of the holes you are going to need to use could be full of crap, so it's best to clean the holes out first with a bottoming, and if you don't have one of those a regular cutting tap will work.

When I put the wide front on my 560, all four holes where the front end bolted on the bolster were full of crap and I had to really work at cleaning them out to get it all bolted up.

installing a wide front on a farmasll H

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

Robert Fallot

New User

jason r

Member

Vito

Well-known Member

Deano4863

Member

ih560

Member

Similar threads