(800) 853-2651
SHOP NOW

front spindles

C

Charles E. McNelly

Member
Hi All,
Does anyone know if the W-6 front spindles will work in the W-9 axle? It looks close but I havent pulled averything apart on both tractors to find out. I would like to run the smaller front tires if I'm able.
Thanks,
Charles
 
charles, here are some part numbers for the w-6 and w-9 front spindles.
for the w-9, it takes part number 58 495 da for the bare spindle, or 58 495 dc for the complete knuckle with washer and nut.

for the w-6 it takes knuckle number 59832 db or 59832 dd for the complete knuckle with washer and nut.
the w-6 uses a 3/4 nut on the axle end, the w-9 uses a 7/8 nut on the end. so it looks like the 9 series used a bigger knuckle.

i have the mccormick parts catalogs for the 9 and 6 series if you need any part look ups. glenn
 
Think they use the same thrust bearing on the spindles. If the W6 spindles are long enough ( don't have one to measure) you may be able to make bushings (if needed) so you could use the complete W6 spindle and wheels. Think the w6 steering arms would need to work also. Think the W9 spindles have splines on top and the W6 have a key. Is this for a pulling tractor?
 
You must log in or register to reply here.

Similar threads

M
Ih350Utility steering wheel and front axle assy
Replies
1
Views
209
Janicholson
Janicholson
M
4020 Wide Front End Spindles - Variations ?
Replies
4
Views
523
mtb34
M
D
farmall 504 diesel
Replies
15
Views
650
BarnyardEngineering
BarnyardEngineering
D
Let's talk front wheels/tires
2
Replies
26
Views
1K
Destroked 450
Destroked 450
T
Looking for Case DCS front axle parts.
Replies
2
Views
408
Tom MacDonald
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top