(800) 853-2651
SHOP NOW

H Countershaft seals

Z

Zachary Hoyt

Well-known Member
I've taken the retainer off and took it with the leaking seals (there are two for some reason) to NAPA. They cross referenced the seal number, which also matched the number given on the CIH web site. The seals they sent me home with are 2.1" OD and the hole in the retainer, now that I got the seals out, is only 2-2.05". The ones I bought are 13602. Does anybody know if that is the correct number or if there is a different one I should ask for? There is a thin metal ring inside the cast retainer that looks like it would make leave a hole close to the right size if I removed it, but it looks like the flange on the thin metal is what holds the seals in. I am sorry not to have a picture to show this. My camera batteries don't charge well enough anymore, and I haven't figured out what brand to buy to replace them. I'm sorry this is so long.
Zach
 
The original seal was a double seal setup all encased in a single outer shell all in one. Sounds like you still have that outer shell in housing and need to take that outer shell out and your seal should work.
 
Thank you very much for your helpful advice. I did what you said about taking out the ring and the new seals fit perfectly. I haven't put the oil back in yet, but it seems like a good fit between the ID of the seal and the nut too.
Zach
 
You must log in or register to reply here.

Similar threads

D
Early 8N oul seal and retainer question
Replies
2
Views
257
Dan
D
G
Ford 861 input shaft seals
Replies
6
Views
415
used red MN
U
M
Yanmar 226D clutch carrier felt seals?
Replies
2
Views
193
mikehill
M
C
Deere 530 clutch bearing retainer removal
Replies
1
Views
292
MSD
M
S
MF 135 leaking oil from underneath where the cotter pin is
Replies
3
Views
262
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top