(800) 853-2651
SHOP NOW

help identify hydraulic system

T

tractorwrencher

New User
Hello,

I won this at auction on a pallet with other parts and don't know what it is.
It has the part number of 361520-R1
casting number of 12 17 Z
Any ideas,

Thanks in advance.

551-534056.jpg

551-534058.jpg
 
What you have is a hydraulic controls off of a 400/450 series Farmall, this mounts behind the dash panel directly behind the fuel tank.It could also be from a 300/350 series, most of the parts are the same.
 
i vote for 300, our 400 looks different than that one. on the 400 the sides of the reservoir are straight up and down, and the fill plug is towards the front with only a couple inches to the forward wall of the reservoir. the 400 dipstick on the fill plug is maybe 8 inches long.

karl f
 
I agree with the others and according to CNH"s lookup it should fit a 300 thru a 450. Allthough the part number is different than that listed on CNH"s parts lookup (they list a 361519-R11), which is just the part number for the column that holds the valves. Everything looks the same and it may just be a revised part number.
 
Although some parts will work on other tractors and it would work complete on a 350 also. Reason I say 300 is because the 2 valves that would be to the right side of tractor when mounted, don't have the extended shafts to change from single to double acting cylinder use. Which they have on a 350 or 450. Then there's the reservoir housing which only fits 300 and 350. 400 and 450 tractors don't have the nose on the front of reservoir that hangs over the belt pulley gear box if equiped like the reservoir in picture.
Also there's the date code and casting number. IH was putting R2 on the end of reservoir casting number well before 300 production ended.
Steel hydraulic lines on front and support bracket only fit a 300 or 350. Unit in picture wasn't equiped for the type of power steering atachment IH offered.
 
You must log in or register to reply here.

Similar threads

L
Farmall H year built
Replies
3
Views
291
LorenMN
L
4
z engine questions
Replies
13
Views
436
4160
4
K
Which fast hitch?
Replies
5
Views
515
Jim Becker
J
Oregon Tractor Jack
Farmall 400 Hydro Pump ID
Replies
3
Views
444
Oregon Tractor Jack
Oregon Tractor Jack
T
ID help TO35 MF35 or something else?
Replies
15
Views
388
Termite
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top