Broken hitch SH

burnsg2003 · Dec 30, 2009

I have a 53 Super H. I was doing some heavy pulling and broke a part of the U hitch. On the axle on the back side there is a about 1 inch square piece of steel that has the two bolts that pivot and hold on the main part of the u hitch. Is this piece the same on H, M SH and SM and what other tractors. How much should I expect to pay. thanks in advance for any help or info.

sflem849 · Dec 30, 2009

There were some on ePay BIN for $25ish. I would expect a junkyard to charge about $10 for them. Make sure you have the ten in your hand when you walk up to pay

Where are you located? There is a good junkyard around here in Fort Atkinson, WI.

armand tatro · Dec 30, 2009

Post a picture of the broken part if you can. It should be possible to weld it. I have done thar before. Armand

burnsg2003 · Dec 30, 2009

I am located in Indiana.

D Slater · Dec 31, 2009

H through 350 or maybe 460 used 3/4 inch diameter bolts and a smaller square tube on front side of axle to clamp your broken piece to axle. M size tractors used 7/8 diameter bolts and a bigger square tube in front. The piviot or eye bolts can be fine thread or coarse. Broken piece is a little thicker on later models. If they fail its usualy where the axle clamp bolt head is close to the end. Should be able to find one reasonable.

Broken hitch SH

burnsg2003

Member

sflem849

Well-known Member

armand tatro

Well-known Member

burnsg2003

Member

D Slater

Well-known Member

Similar threads