(800) 853-2651
SHOP NOW

sleeve puller

W

WOpp

Member
Do any of you guys know where I could buy a good used sleeve puller big enough for SWD9 or 650? Thanks Warren
 
if the sleeves are no good the simplist way to get them out is to weld 2 beads 180 degrees apart and then you can just pull them out by hand.
 
You would probably need one like Keith made for his Super C. You would need to have a puck machined undersize about .020" to clear the sleeve bore and enough to clear the block bore. Hal
2yxkl5u.jpg
 
You must log in or register to reply here.

Similar threads

G
C264 SUPER M BLOCK
Replies
7
Views
534
caterpillar guy
C
C
Super C input shaft seal replacement
Replies
1
Views
131
Charlie M
C
M
SWD9 battery ground
Replies
7
Views
335
John T
J
C
806 Sleeves
Replies
7
Views
441
the tractor vet
T
C
Case 732 rear axle hub removal
Replies
7
Views
336
pcrh
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top