(800) 853-2651
SHOP NOW

Starter Bendix

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

F

FarmallJoe

Member
Hi All, my new bendix just came in for my farmallA. I was looking for either a point in the right direction (link etc) or some step by step instruction to replace the starter gear. photos would be great but dont want to ask too much. Thanks a lot!
 
I'm guessing that you've got one of the new clutch type drives. When I got mine it was 'how the heck does this go together?' But if you take the starter apart like you were replacing the drive, you will see how it goes back together with the new drive.

Without taking mine apart again, I can't give you a better description.

Greg
 
In general, mark both ends and the middle so you can get the drive end and the brush end back the way they were. Take the two long bolts out of the back and pull the drive end off. If you don't remove the back end you won't have to deal with getting the brushes over the armature when you put it back together.

Once you get the front end off the old drive will come off and the new one can go on. Put a little smear of grease on the shaft and the bushing in the nose.

You'll see when you take it apart.

Greg
 
You must log in or register to reply here.

Similar threads

W
Ford 8N bendix recovery
2
Replies
24
Views
2K
showcrop
showcrop
D
Allis WD-45, or D17 flywheel starter ring location?
Replies
15
Views
672
docmirror
D
8
Starter problems
Replies
16
Views
850
8NHENRY
8
B
Case 530 Bendix steering function question.
Replies
4
Views
330
BearNE
B
P
350 U. Rethinking the 1 way power steering
Replies
3
Views
302
Janicholson
Janicholson
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top