(800) 853-2651
SHOP NOW

Hey Glennster, question about your M

H

hoof print

Member
Say Glenn, I noticed you installed your original drawbar with your Saginaw 3pt.

I have a saginaw 3pt on an H and have considered installing the draw bar. I knew that it was possible to do so, but I always worried that I may not get full downward motion from the 3pt lift arms. Ever had any problems with your lift arms hitting the draw bar, or needed them to go lower than they are allowed to with it?

By the way, that is some neat M you have, I would love to have power steering and a welder on my old workhorse H.

I do have an original IH 2 way hydraulic valve, the saginaw 3pt I mentioned. Mine sure is a hand tractor.


I was looking through your photo bucket for more pictures of your m and saw what appeared to be an AMC Javelin! Am I correct on that? I have always wanted an AMX myself...love the old AMC's.
 
i dont have a problem wih the travel length on the three point. in the full down position, it gets real low. with the 9 spped and power steering its prolly my favorite of my three m's. i have a super m in the works right now, trying to get er done by spring, (but its been an off an on project for several years) the javelin belongs to one of my customers. started that over a year ago. body has been media blasted, sheet metal replaced, 9 inch ford rear end, motor has been tricked out, fresh trans, big dollar restoration, but it will be one sweet ride. we located the original dealer installed side pipes for this varmint too. should be going in to paint in the next couple weeks.
 
You must log in or register to reply here.

Similar threads

D
M rear end
Replies
10
Views
1K
Whiskey Bent
W
R
Another D14 story long..ish and a question about belt pulleys...
Replies
0
Views
218
rasman57
R
Southern Ray
Mounting implements the easy way
Replies
5
Views
462
Geo-TH,In
Geo-TH,In
M
Super M Stage 1 REAMAN (More parts..)
Replies
6
Views
809
mike1972chev
M
C
800 hydraulic pump confusion....problem?
Replies
4
Views
441
Centerline
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top