Seal on govenor housing on M

linemanfarmer · Dec 6, 2009

I am leaking oil behind the govenor on my M.. I belive there is a seal, but have no idea on what it would take to change it out. Any ideas?

Thanks

D Slater · Dec 6, 2009

After governor housing is removed from tractor.
Remove housing cover, front arm that spring is hooked to and key from throttle shaft. Pull throttle shaft out and you can see the seal in housing. Not hard to do, 2 of the three 3/8 bolts that hold governor on engine screw into it from the front side of front cover.

gab · Dec 6, 2009

I just did that a couple weeks ago, not hard to do. I think the seal box is still on the bench, I'll go get the number. Federal Mogul 470119

glennster · Dec 6, 2009

check your throttle shaft for wear too. i just went thru the governor on the super m i am rebuilding and the throttle shaft was pretty well wore out. about 105.00 for a new one from case ih

Zach Bouchard · Dec 7, 2009

I found it on NAPA for $6.66. Not too bad and you can get it online.
Here it is on napas page

Seal on govenor housing on M

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

linemanfarmer

Member

D Slater

Well-known Member

gab

Well-known Member

glennster

Well-known Member

Zach Bouchard

Member

Similar threads