tackhammertime
Member
I have tried with no luck to move the lever to engage my belt pulley on the A. I will not move so were do I start looking at the fix.
- Thread starter tackhammertime
- Start date
Janicholson
Well-known Member
If it does not move any, not even a tiny bit, the shaft is rusted in place. Heating the shaft at the lever. then cooling, then using penetrating juice, then heating and working on the lever will eventually free it up. If it does move some, it might need to be taken apart to free up an internal component.
farmall hfan
New User
Thanks it is something on the inside.
tackhammertime
Member
My brother farmallhfan thought we could take the belt pully off and get to the problem but when we took the 4 screws out of the belt pulley it will not come off. I can't find in the service manual the proceedure can someone help thanks.
ScottyHOMeY
Well-known Member
If the bolts are out, there shouldn't be anything holding it except paint, gunk and the possibility of somebody having used some cement on the gasket. A few smart but judicious blows with a soft deadblow hammer ought to break it free.
tackhammertime
Member
Bolts are out and it has about 1/2 inche between the two peices. Is it connected to the lever in any way? It moves when we pry on it. We are wandering if it maybe all bound up and the reason the lever will not move.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy