(800) 853-2651
SHOP NOW

help IDing sickle

T

tipper

Member
Anyone out there have some ideas on what this cutter might be?
i50237.jpg
i50238.jpg
i50239.jpg
i50240.jpg
 
that is a IH mower model C-24-P or possible C-21-P but pretty sure its the 24 it has the duall lift springs on the back. that mower will fit a Super C, 200, 230 ect with the fast hitch. They could be ordered with 5, 6, and 7 foot cuts.

Andrew
 
Agree with the model number. I will add that it uses a lift rod that connects to the left side of the Touch-Control. Most 230s didn't have Touch-Control so the mower wouldn't go right on them and completely hook up as it would on the earlier tractors.

From the picture, a chain can be seen attached where that lift rod goes. So this mower may already be configured for a 230. In that case, you will need to add a rod to use it on the earlier tractors.

Did that muddle the picture enough?
 
Not sure what it is. I can say, if it's helpful, that it's not a 21. The double spring wouldn't be right, the pulleys are not one above the other as on a 21, and the transport stay rod is way too long.

I've got my doubts about it even being a 24, which was pretty just much a beefed-up version of the 21, and that box, and that bow around the bearing boxes isn't at all familiar.

The 21 and 24 were made for two different frames, one for the A series and the other for the Cs. I'm guessing from the relative size of that Fast Hitch, that it was for an H or M, but I don't know them well enough to come up with possible model numbers.
 
ScottyHOMEy,
With a closer look, I can see that you are right. It isn't a 21 or a 24. There was a model UF-28 that might be a match. I don't have a picture for identifying one. There is a picture in the 350 sales brochure of a similar one, but the model isn't identified with that picture.
 
You must log in or register to reply here.

Similar threads

acorn
New Project! Unknown 2 bottom plow
Replies
11
Views
524
acorn
acorn
M
Sickle Bar and Plow ID
Replies
16
Views
524
mainer76
M
D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
484
gene bender
G
H
  • Question
Farmall A sickle bar
Replies
17
Views
687
1946 BN IHC
1
H
JD 38 Sickle Bar Mower mounting brackets
Replies
5
Views
398
tomstractorsandtoys
tomstractorsandtoys
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top