Sedament bowl seat

S/C BOB · Nov 17, 2009

Well I just sandblasted the Bowl housing for my S/A Farmall and it looks so nice BUT it looks like I lost the seat in the process...What do you guys use in this case? Thanks Bobby

ScottyHOMeY · Nov 17, 2009

What are you calling the seat?

S/C BOB · Nov 17, 2009

When you turn the gas off the needle goes in to shut off the gas...and where it hits the stop I call that the seat

Bob M · Nov 17, 2009

Ummmm....I don't believe there is a separate seat in the sediment bowl assembly. Rather the "seat" is simply machined directly into the zinc casting.

I suspect your sandblasting tore up the seat area in yours. Or perhaps there's a bit of sand now embedded in it.

Either way your best bet is to purchase a whole new sediment bulb assembly. They're readily available and not terribly expensive.

Jeff Z. · Nov 17, 2009

Sounds like a trip to Tractor Supply for a new bowl.

504-2 · Nov 17, 2009

I bought one last week for a 400, $27.00 at the farm store.

gene bender · Nov 18, 2009

Did you have the shut-off l-shaped lever out? Or you needing a new gasket and screen where the glass bowl seats.

rustyfarmall · Nov 18, 2009

Over the years I have purchased 4 or 5 new sediment bowl assemblies from local farm stores. Not a single one of them will actually STOP the flow of fuel when I shut it off.

Sedament bowl seat

S/C BOB

Member

ScottyHOMeY

Well-known Member

S/C BOB

Member

Bob M

Well-known Member

Jeff Z.

Well-known Member

504-2

Member

gene bender

Well-known Member

rustyfarmall

Well-known Member

Similar threads