(800) 853-2651
SHOP NOW

IH Wide Front End

D

Deano4863

Member
Hi Guys,
I"m working on an IH WFE with the tie rods out front. The hubs had approx 1/8" play in and out before I dissassembled, cleaned and repacked the bearings. Everything seemed to be ok. I adjusted/tightend the castle nuts. Both castle nuts are past the cotter key hole in the spindle and 1 hub still has a little play in it. Any suggestions?
 
i have fixed this problem on one of my ih frontends by puting a thin shim around the shaft before puting the arm on a flat piece of tin can is what i used pc
 
You must log in or register to reply here.

Similar threads

J
Case IH 895 steering issue
Replies
3
Views
222
MARK ROBKE
M
J
TO35 pto clutch or clutch shaft?
Replies
2
Views
167
John Deere D
John Deere D
N
JD B front spindle w/moderate wear...
Replies
3
Views
446
crooked rows
C
J
630 Rollamatic Spindle
Replies
4
Views
553
David.DeHart
D
MarkB_MI
EZ-Lube hubs
2
Replies
31
Views
2K
MarkB_MI
MarkB_MI
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top