(800) 853-2651
SHOP NOW

Starter drives

R

Robert Lorencz

Member
Good Morning
I have been reading some posts here about starter drives, in particular the clutch type. So.. I bought one to see how easy it was to replace, and ran into this problem ....how do I remove the set screw from the new drive so I can slide it over the shaft - it is half covered by end washer.
p50123.jpg
 
No particular method, vise or channel lock pliars to pry washer ahead just enough to get screw out part way so it clears shaft. They are a little difficult but they will come around. As you can see, it has no overrunning clutch and is engaged by irertia so not actually clutch drive. Also, use only the small washer on drive end so as to control end play of armature.
 
You must log in or register to reply here.

Similar threads

P
856 pto driven gear removal
Replies
5
Views
301
Janicholson
Janicholson
T
140 transmission
Replies
3
Views
252
K-Mo
K
G
Super A governor adjustment
Replies
5
Views
292
560Dennis
560Dennis
M
Super M transmission shaft seal
Replies
7
Views
232
Mark Poss
M
D
Farmall300 ta
Replies
5
Views
301
dewy
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top