Little Wonder plow parts help

2 Questions.

1. I bought a Little Wonder 2 bottom plow, I think a 14in bottoms. It needs new landslides. Where can a person buy them at?

2. I think it might be missing a part on the front. I am going to try to upload a picture I found on the internet. (my plow doesn't look this good at all) If the picture works you can see what looks like a piece of steel with holes in it that is above the hitch. It looks like it goes to a bracket on the plow and then to the hitch near where the clevis is....now my plow doesn't have that part...and I was wondering if any of you could give me a measurement on what that part is like and how it hooks up. I could make one if it is not too difficult...or do I even need it? I have never been around a Little Wonder plow before.
Thanks for your help.
Mike at [email protected]
i50185.jpg
 
It is 3/8" X 1 1/4" X 32" long. There are 8, 1/2" holes 3/4" on center at the top and 1, 1/2" hole at the bottom.
 
(quoted from post at 14:44:14 11/08/09) It is 3/8" X 1 1/4" X 32" long. There are 8, 1/2" holes 3/4" on center at the top and 1, 1/2" hole at the bottom.
Thanks much for the information. I will make one. You are a big help! Thanks.
I can see where it attaches on the top with all the holes. But where does it attach on the other end. I have not been able to see a photo that shows that yet. Does this piece stablize the tongue of the plow? I had a little Genius plow once and it didn't have anything like this that I remember.
Thanks again,
Mike
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top