Author [expand]	[Modern View]
Linemanfarmer 10-28-2009 16:54:32 68.103.100.34 735362 Report to Moderator	Hey guys, We are trying to restore a W-9. The parts are coming by as hard to find. We have found some engine parts...but is not cheap at all. We have bought H and M parts but these w-9 sleeves, pistons, rod bearings, and rings are pretty expensive. Any advice on what you guys have done, seen or where to go, we'd appretiate it much. Thanks, Derek [Reply]   [Send Email]
El Toro 10-29-2009 17:30:51 74.103.74.58 735562 Report to Moderator	Re: w-9 parts...hard to find? in reply to Linemanfarmer, 10-28-2009 16:54:32   Weberstractorworks has sleeve kits for about $1500.00. Hal   [Reply]   [No Email]
glennster 10-29-2009 06:18:39 76.217.101.141 735457 Report to Moderator	Re: w-9 parts...hard to find? in reply to Linemanfarmer, 10-28-2009 16:54:32   w-9 engine parts are very spendy. pistons and sleeves especially. berkshire equipment in royal center indiana has some nos available, as does bates corporation in burbon indiana. last time i checkes, bates piston and sleeve asem"s run about 595.00 per cylinder, so figure around 2400 for the kit. one thing i have not found is the fuel pump rebuild kits for the w-9. they ran 2 different a/c fuel pumps. there was a fellow up in mn that used to advertise in red power magazine that had the fuel pump kits, but i havent been able to contact him. i think his name was joseph faust.   [Reply]   [Send Email]
scott mcintosh 10-28-2009 20:53:17 216.180.197.84 735429 Report to Moderator	Re: w-9 parts...hard to find? in reply to Linemanfarmer, 10-28-2009 16:54:32   Try powermaxparts.com.Scott   [Reply]   [No Email]
M Diesel 10-28-2009 18:02:41 12.24.61.12 735376 Report to Moderator	Re: w-9 parts...hard to find? in reply to Linemanfarmer, 10-28-2009 16:54:32   Have you talked to weberstractorworks.com? Them 9 parts is a royal pain. <_<   [Reply]   [No Email]