(800) 853-2651
SHOP NOW

Farmall C front pulley

H

HSE

Member
What holds the pulley on the front of the crankshaft on a Farmall C? I looked it up in the parts manual, but did not find anything.

Putting one of those projects together that was taken apart ten years ago and been setting in the corner of the shop.

Thanks for any help
 
Tension fit.

When you're ready to put it on, have the tractor near the house and send the missus to the county seat for a tube of relative bearing grease and two 6" postholes -- anything that will keep her away for a while.

Clean the end of the crank pulley up well with brake cleaner or whatever you have that doesn't leave any residue to smell up the place and pop it in the oven at about 250 for an hour or so. Use oven mitts and RUN (like the wife is just pulling into the driveway) to the tractor with it. Line it up with the key and should slide right on. Hold it there for the short time it will take to shrink onto the end of the crank. Some will take a quick rap with a rubber mallet to go the last little bit (don't beat too hard or too long, you can mar the thrust faces on the mains), or there is a thread in the end of the crank that allows you to stack a couple of washers under a bolthead to finish drawing it on.

Have a batch of cookie dough handy to throw in the oven to make the place smell like fresh cookies in case there was any oil or grease left on the pulley.
 
Thanks for the replies!

Always fun to know your looking for parts (bolts) that don't even exist!

I thought I was they only one with a wife like that! :)
 
LOL!

I too waited, until the redhead was at work for the day.
One of those "what she doesn't know, won't aggravate her" things!

Did the same thing with the ring gear. =:)
 
You must log in or register to reply here.

Similar threads

M
IH350U-C175 crankshaft pulley.
Replies
5
Views
212
13fx
1
H
Farmall Super C
Replies
2
Views
413
rustred
rustred
1
Int 300/350u front hyd pump
Replies
3
Views
199
13fx
1
W
560 Valve setting
2
Replies
23
Views
981
WHFarms
W
C
310 front pulley wear sleeve
Replies
3
Views
441
GermantownGreen
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top