John G. Hasler
Member
Any suggestions on how to identify the loader on my 560? All it says on it is "INTERNATIONAL". It"s full hydraulic with a single "push" cylinder for the bucket.
- Thread starter John G. Hasler
- Start date
soybeanjoe
Member
That could be one of a dozen makes of loaders. We need a LOT more information. Pics would really be helpful.
Hugh MacKay
Well-known Member
John: If it is a pipe frame loader, (very unlikely as they were 400-450 vintage) two possible choices 33 or 33A.
Next came the 1701 and 2001 both used on 460-560 tractors, and the last loaders to have sub frame go back to rear axle carriers. 2001 is quite a bit heavier, most likely the one chosen for 560. Sub frame is exactly same as 2000, only real difference in the two loaders is end of lift boom. 2001 has one dump cylinder in center, 2000 has two dump cylinders, one on each lift arm.
Next came the 1701 and 2001 both used on 460-560 tractors, and the last loaders to have sub frame go back to rear axle carriers. 2001 is quite a bit heavier, most likely the one chosen for 560. Sub frame is exactly same as 2000, only real difference in the two loaders is end of lift boom. 2001 has one dump cylinder in center, 2000 has two dump cylinders, one on each lift arm.
TomH in PA
Well-known Member
I agree with Hugh. Here's a picture of a 2001.
![2001Loader.jpg"](http://"http://i125.photobucket.com/albums/p64/wRNIVmg0/2001Loader.jpg"/)
John G. Hasler
Member
Nope. That"s not it. The subframe runs straight back to the axle and the dump cylinder mounts via its far end against a cross-member.
Hugh MacKay
Well-known Member
John: That leaves 1701 if it has non pipe frame.
John G. Hasler
Member
It has a non-pipe frame but it also has a subframe that runs straight back to the axle and the dump cylinder is not mounted the way the ones on the 1701s I can find photos of are.
Perhaps it is not an IH loader at all despite the INTERNATIONAL decal.
Perhaps it is not an IH loader at all despite the INTERNATIONAL decal.
Hugh MacKay
Well-known Member
John: It wouldn't be the first time I saw a non IH loader with International on it.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy