Mounted plows for my H

Stumpy · Sep 27, 2009

Hey Fellas, I"m looking for some info on mounted plows. I have a "44 H. A friend has offerd up a set of mounted two way plows. I am curious to 1) identify what plows went on an H an 2) find a manual reprint or download for them.

Any info is greatly appreciated!

Stumpy

Janicholson · Sep 27, 2009

I have never heard of a mounted H plow. So it would be new to me. JimN

CNKS · Sep 27, 2009

I very vaguely (don't remember what happened this morning, much less 60 years ago) single furrow belly mount moldboards-perhaps not. Don't know why anyone would use them. H/M 150 semimounted disk plow is the only one I have ever seen, and used.

D Slater · Sep 27, 2009

If its the type that one plow plows one dirrection and the other bottom plows going back and turns the furrow in the same dirrection.
Look for information on models H 86 or M 188.
Some of the mounting parts go all the way to frame rails. If it has 2 bottoms for both dirrections, 4 total its rare.

BEC · Sep 27, 2009

You are looking for the H-86 two-way tractor plow for Farmall H with Lift-All attachment. The H-86
two-way plow is built for use with Farmall H.These are quick-attachable plows which can be put on the tractor in 5 min or taken off in less time.You will have to take off the draw bar first. The beams are long and attached well under the tractor. The depth is controlled by guage wheels through a locator lever. Each bottom is suspended from the rock-shaft arms by parallel links which stabilize the plow. Slotted bars between the links permit the bottoms sufficient lateral motion so they cannot interfere with easy steering.-----The M-188 differs from the H-86 because it is much heavier.It has a higher clearance under the beams.It has extra high landsides with wide , adjustable heel castings. Either of these plows can be equiped with 14,16 or 18 inch bottoms. Two 2 1/2 cylinders are required. One for each side of tractor. Hope this helps you identfy the plows you are looking at. I don"t know if the M-188 will work on the H or not. BEC

gene bender · Sep 27, 2009

The H-190 was built from 46-54. The H-186 two-way was built the same period The parts book shows all parts ect. Both models were available with 14,16 and18in bottoms.

Cedric · Sep 28, 2009

I had an H-190 for my H, which has since been sold. However, there are a couple of photos of the plough under the heading "H-190 Plow". By mistake I put them in the Tractor Photos Gallery instead of the Implements Gallery.
I'm pretty sure the H-190 is the right hand side of the H-186 two way plow set-up.
You will find that it will take more than 5 minutes to get this plow fully set up on the tractor. Sid.

BEC · Sep 28, 2009

The H-90 is the right side of the H-86 2-plow system. It is for the right side. BEC

BEC · Sep 28, 2009

The H-90 is the right side of the H-86 2-plow system. It is for the right side. BEC

Mounted plows for my H

Stumpy

Member

Janicholson

Well-known Member

CNKS

Well-known Member

D Slater

Well-known Member

BEC

New User

gene bender

Well-known Member

Cedric

Member

BEC

New User

BEC

New User

Similar threads