TA will not shift out of low!

Elvared · Sep 21, 2009

I have a farmall 340. This weekend while pulling a disk the TA
quit shifting into hi! It has always made sharp quick shifts but now stays in low. The TA shift lever feels like its not shifting but adjusting the linkage made no difference. Any help out there??
Thanks Wayne

D Slater · Sep 21, 2009

If you remove the t/a linkage pins from the shaft closest to operator and the shaft will move clockwise and counterclockwise freely for a short distance there's a problem with the t/a clutch. Its not holding for some reason, maybe stripped the splines on t/a shaft that center of t/a clutch plate goes on if it done it at once with no noise. Also check for oil at drain holes on bottom of center housing in case a seal let oil get to clutch. Unless your linkage happend to be bond up a tear down is needed.

Elvared · Sep 23, 2009

Thanks for fast reply. I will check your advise this weekend. Somehow I always thought the low would be the one to wear out first. I'll let you know what I found out Monday.
Elvared

TA will not shift out of low!

Elvared

New User

D Slater

Well-known Member

Elvared

New User

Similar threads