(800) 853-2651
SHOP NOW

Drawbar clamp questions

M

Mike CA

Well-known Member
Will the drawbar clamps from an M work on an H? The part numbers are slightly different, but I can't visually tell a difference in size.
I saw some drawbar clamps in great shape on an old MD today, and would love to get them and be done with it!

H drawbar – 51716DXB/51715DA
M drawbar – 5171[b:86b31d58c6]8[/b:86b31d58c6]DXB/5171[b:86b31d58c6]7[/b:86b31d58c6]DA
 
There not exactly the same, Its a tight fit, but rear part of clamp will usualy squeeze in the slot in a H axle housing. Most M had the front square tube that was pretty square on the corners and won't go in a H axle slot. If its got the ones like they started using about the time 400 tractors came out, they are more rounded on one side and will usualy squeeze in slots. M has 7/8 inch diameter clamp bolts and H has 3/4.
 
You must log in or register to reply here.

Similar threads

cpratt
I can't tell what I've already read?
2
Replies
32
Views
1K
Rich'sToys
R
B
Farmall 300 and 350 - A Few More Questions
Replies
8
Views
2K
Bill VA
B
Gambles
IH H oil filter-part deux (boring and long)
Replies
3
Views
304
Gambles
Gambles
T
Tractor trivia questions followup (long)
Replies
17
Views
2K
Trkr
T
F
Oliver 1800 B Series Questions
Replies
6
Views
2K
Don-Wi
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top