H two way hydraulics

David G · Sep 14, 2009

I am planning my winter work on my dads H. I would like to add 2 two way remotes. Can someone tell me where I need to pipe to, and where do I set the liftall lever. This will make it a nice tractor for hay raking.

I would like to mount the OC control valves on the light bar.

Thanks,

Bob Kerr · Sep 14, 2009

IH had a remote valve for Hs. you need to find the valve and the rods to go with it. One rod sets the belly pump to full time pumping or off and the other rod controls up or down.

gene bender · Sep 15, 2009

Is is easy to mount on the lite bar. Hooh the pressure side to the outlet of the belley pump and the return to the bottom of the belley tank where you would drain. Get a open center control valve. Then you need to have the lift--all lever back. You can fasten it back full time. Then run your two outlets on the new valve to the rear and you now have a two-way system.

Janicholson · Sep 15, 2009

This might help. JimN

jam pa · Sep 18, 2009

I have a question of my own. I have an H with a front loader and 3pt.
The setup has always worked pretty well but lately the FEL doesn't have much power the higher it goes and now won't lift all the way even empty.
I had a brush hog mounted and when I dropped the hog the FEL would raise another foot or so which makes me think the system doesn't have enough fluid.
Is there a danger of over filling the hydaulics? This tractor is plumbed to dump the return back into the fill with a T. Should the fill be capped tight or vented? I didn't want to blow a seal in the pump with too much fluid being sent back to the pump.
thanks.

H two way hydraulics

David G

Well-known Member

Bob Kerr

Member

gene bender

Well-known Member

Janicholson

Well-known Member

jam pa

New User

Similar threads