pertronix coil

LN · Sep 12, 2009

should you have an inline resistor before the coil of a farmall M when using pertronix ignitor #1442 and pertronix coil #40611 40k volts have read the literature and listened to a lot of advice but would like to know for sure before I burn it up

Jeff Z. · Sep 12, 2009

No resistor needed with that coil.

JMOR · Sep 12, 2009

(quoted from post at 10:40:23 09/12/09) should you have an inline resistor before the coil of a farmall M when using pertronix ignitor #1442 and pertronix coil #40611 40k volts have read the literature and listened to a lot of advice but would like to know for sure before I burn it up

If you are still 6v, then with that 3 ohm coil, you are only running a meager 2 amps.........not going to burn it up, but not a lot of energy either. I believe that if you contact Pertronix, you will find that it is intended to run at about 4 amps.

LN · Sep 12, 2009

12v negative ground

JMOR · Sep 12, 2009

(quoted from post at 19:41:01 09/12/09) 12v negative ground

ounds like all is well.

pertronix coil

LN

Member

Jeff Z.

Well-known Member

JMOR

Well-known Member

LN

Member

JMOR

Well-known Member

Similar threads