(800) 853-2651
SHOP NOW

SH Clutch adjustment

D

Deano4863

Member
Hi Guys,
I'm working on a super H with the Rockford clutch. This clutch has a bolt on each of the 3 arms that comes into contact with the throw out bearing. What is the adjustment on those supposed to look like? I have the external linkage adjusted to 1 1/8" from the platform. Thanks in advance.
 
If you have not moved them, and you feel no one after the factory production messed with it, leave it alone. There are adjustment numbers, but not when installed. JimN
 
(quoted from post at 17:47:18 09/06/09) Hi Guys,
I'm working on a super H with the Rockford clutch. This clutch has a bolt on each of the 3 arms that comes into contact with the throw out bearing. What is the adjustment on those supposed to look like? I have the external linkage adjusted to 1 1/8" from the platform. Thanks in advance.
Click to expand...
If your free travel is 1-1/8" off the edge of the deck and the clutch is engaging smoothly, then don't worry about it. Unless you are riding the clutch a lot, or constantly starting off in 5th with a load hooked to the tractor, it will probably last you another 10 years easy....
mike
 
The original screws had 90% of the head ground off so I replaced them. I measured and counted the threads on the originals and put the new in the same distance. The assumption is that new bolts from IH would put things back in spec. Dealer inspected the clutch pressure plate and recommended new screws only.
 
Don't know yet. I just finished rebuilding the motor and am putting everything back together. It'll be a while before I can fire it up. I am prepping for paint now.
 
You must log in or register to reply here.

Similar threads

P
Cub throwout yoke hits clutch pressure plate when depressed, cause?
Replies
14
Views
386
Jim Becker
J
R
Super C clutch pilot bearing
Replies
7
Views
427
Roger46
R
G
656 clutch TA
Replies
7
Views
367
gaughan30
G
M
MF 65 OM Correction: Clutch Linkage Adjustment
Replies
3
Views
386
Bob NY
Bob NY
R
Clutch throwout movement
Replies
9
Views
545
Janicholson
Janicholson
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top