(800) 853-2651
SHOP NOW

Super A and woods mower

O

Oldiron29

Well-known Member
Trying to mount a L503 on super A. Do you need to remove Draw bar studs and replace with bolts?
Does anyone have a picture of the rear bar mounted they would share? Thanks oldiron29
 
I have a Woods book but it doesn"t show it clearly. I recently mounted the L59 on mine, I removed the stud from the front on each side and used bolts and nuts for the front top and bottom then used the drawbar bolt for the third bolt on each side. Not certain whether they were 1/2 or 5/8" bolts.
 
peculiar, That is what I thought the studs would have to be replaced with bolts. Now I have to try to get them out. oldiron29
 
Having trouble downloading pictures from camera, will fight it a while longer. Meanwhile I scanned this page of the manual which should show belt twists.
a4452.jpg
 
I would replace the front idler that is v-grooved with a smooth one and do away with the half turn of the belt coming off the drive. It works much better as it is hard to have such as twist in a short space. New mowers come that way.
 
I have the same setup on my SA / L503 and was considering the same thing...a flat double-flanged pulley to take the 1/2 twist out.

I also do not have a drawbar on my tractor...don't really need one as of right now.

The Woods documentation is a little shy on SA/L503, as I recall the one manual for the L503 is for a Ford 8N install.
 
You must log in or register to reply here.

Similar threads

A
Super C Fast Hitch
Replies
10
Views
437
ajhbike
A
D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
485
gene bender
G
1
Farmall Super A hydraulics question.
Replies
9
Views
432
BarnyardEngineering
BarnyardEngineering
T
John deere sickle mower
Replies
4
Views
664
ajhbike
A
H
Cub Steering Housing Gasket Repair
Replies
4
Views
278
Hotflashjr
H
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top