Farmall A hydraulics

Anonymous-0 · Aug 17, 2009

Is there any way to add hydraulics to a plain "A" besides adding a PTO pump?

Scotty · Aug 17, 2009

Good Afternoon Bob,
Some fellas have fabricated hydraulics on their A by using an old power steering pump, and running it off of their fan belt. You would need a couple of brackets and a larger fan belt to accomodate another pulley.
Try doing a search and you may come up with some older threads on this issue !

scotty

Steven f/AZ · Aug 17, 2009

http://ytforums.ytmag.com/viewtopic.php?t=256223&postdays=0&postorder=asc&highlight=hydraulic&start=15

Janicholson · Aug 17, 2009

Changing the block to a SuperA, C or Super C would also do it. JimN

Hugh MacKay · Aug 17, 2009

Jim: You also have to change the torque tube, Super A torque tube is flat on top to accomodate factory hydraulics. Farmall A torque tube is round on top. Most will agree, you may as well go buy a SA, as change both block and torque tube.

John P. · Aug 17, 2009

I also saw someone on here run the pump off the belt pulley.

Steven f/AZ · Aug 17, 2009

(quoted from post at 16:21:43 08/17/09) I also saw someone on here run the pump off the belt pulley.

Running from the crankshaft pulley would be easy, too...

Anonymous-0 · Aug 18, 2009

True if going for a full IH based system. I was just getting a pump on it, assuming the system would be adhock as well. Jim

Farmall A hydraulics

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

Anonymous-0

Well-known Member

Scotty

Well-known Member

Steven f/AZ

Well-known Member

Janicholson

Well-known Member

Hugh MacKay

Well-known Member

John P.

Member

Steven f/AZ

Well-known Member

Anonymous-0

Well-known Member

Similar threads