(800) 853-2651
SHOP NOW

magneto oil

R

Rossputin

Member
Hello again, everyone.

A few more small questions:

1) How much "sewing oil" should go into the impulse coupling on my Farmall B?

2) When I open the lid for the magneto oil (between the distributor's metal clip and the body of the tractor), the little space in there seems to be blocked. I'm wondering if that's right and I'm correctly putting oil into some sort of material that holds it, or if I need to try to get out whatever is in there... As it was, I could only put a few drops of oil (same type as for engine) in before it overflowed.

Thanks again,
Ross
 
1) Just a few drops.

2) Normal, unless it is full of dirt. The blockage is the part that oil is going to lubricate.
 
If it is dirty, you can usually pull out the piece of felt material (needle nose etc) and clean it with solvent. The felt absorbs oil and slowly lets it fall onto the working parts. It may have to be replaced, they are normally pretty cruddy and dirt packed.
 
You must log in or register to reply here.

Similar threads

B
Oil on my Plugs, but WHERE is it From?
Replies
11
Views
389
used red MN
U
G
1949 B Oil Filter Body
Replies
13
Views
992
Gwiz
G
J
Case 430 Hydraulics
Replies
6
Views
766
45cole
4
R
TO30 Hydraulics (part 3)
Replies
2
Views
536
ruschman
R
C
SOS Massey Ferguson HELP--Update
Replies
6
Views
518
Bill(Wis)
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top