(800) 853-2651
SHOP NOW

706 emblems and injector pump leak at line

A

Anonymous-0

Well-known Member
I recently purchased a 706 diesel and the side panels say "International". My other 706 says "Farmall". Both are row crops. Is International correct????

Secondly, on the diesel it is shooting out a small stream of diesel fuel (not high pressure at this time/just a small stream) at the injection pump where one of the injector lines hooks on. Looks like the pipe hooks to a circular fitting and a bolt goes through the center holding the fitting tight to the pump. Does it just need to be loosened and retightened? Sanded? Filed flat? "O" rings?? Thank you.
 
Mine was leaking after mowing yesterday. It is a d282 with the roosa master pump. Go get some new copper washers just take the old one with u to the parts house. Don't try to get it to tight when u put it backcause it will leak again. Only do one line at a time and start it cause those engines are hard to start when everything is working anyway.
 
sounds like a "banjo" fitting. not sure about the roosa master, but the 806 with RD pump uses banjo fittings which take 2 little white sealing rings each.
 
You must log in or register to reply here.

Similar threads

F
Need advice on the fuel line going to pump.
Replies
3
Views
247
rustred
rustred
3LFarms
IH injection pump internal fuel leak?
Replies
5
Views
300
3LFarms
3LFarms
S
Old 350d c series injection pump crank no start.
Replies
0
Views
180
Scotty2track
S
Q
IHC 806 won't start
2
Replies
27
Views
776
rustred
rustred
C
cbc injector pump leaking at throttle rack and pinion
Replies
3
Views
494
cwheat
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top