806 pto leaks

bob from ill · Jul 29, 2009

need to replace the 1000 rpm pto rear seal on my dual pto. can it be pulled out with slide hammer, or does the unit need to come off tractor to replace?

Mark in Upstate · Jul 30, 2009

PTO will need to be removed and tore apart. There is an adapter for the 540, not the 1000.

Owen Aaland · Jul 30, 2009

(quoted from post at 19:21:17 07/29/09) need to replace the 1000 rpm pto rear seal on my dual pto. can it be pulled out with slide hammer, or does the unit need to come off tractor to replace?

Just be careful not to damage the shaft or housing when you removed the seal. The new one can be installed without any other disassembly.

bob from ill · Jul 30, 2009

the origanal housing had a crack by bolt flange and was seaping oil out for a few years. finally decided to repair. tried to weld crack but kept shrinking and a crack would form again. anyways, got a used replacement btu it had the seals removed already. I was able to press out my seals, there was a couple of chips in otherhousing where someone wasnt careful removing seals. pressed in seals, niether leaked from rubber element but it leaked where the chips were. since it wasnt a pressure leak, I applied permatex cold weld, same as jb weld. if it didnt work i wasnt out anything but ten minutes it takes to harden. it worked like a charm.

806 pto leaks

bob from ill

Member

Mark in Upstate

Member

Owen Aaland

Well-known Member

bob from ill

Member

Similar threads