(800) 853-2651
SHOP NOW

Pneumatic Lift all

D

Don in Texas

Member
Have bought a lift all that was removed fron a 1944 Farmall A and want to install it on my A. Trouble is, I do not know how and where all the pulleys, valves and cylinders are bolted to the tractor. Have the lift-all Owners Manual and A service manual but none show how or where to bolt the pieces to the tractor. Is there a source for diagrams or pictures? Would this system operate by a 12 Volt air compressor? Have a cultivator on tractor now.
 
Contact Village Power Equipment in Berlin, MA at
978-838-2484 to see if they have a diagram or picture of that exhaust lift. I think they may have parts too. Hal
 
Your best source on this forum that I know of is a guy named Gene Bender. He has more than one of these units working on tractors he owns if I remember correctly. Look for an old post of his with e-mail open and send him a note. Be patient, he is a busy guy. Also, look in the archives of Red Power magazine for an issue with an article on these and order it. It was a couple years back but good article for reference.
 
A 12v compresser wont have enough flow to lift as it would take several minutes to get enough volume to operate the cycl. There arent any pulleys to make the system work. There are pulleys and a cable to make the cultivators work. Send an e-mail and i can give you my cell# I use them on the plow and cults on the A and B. some parts are no longer available.
 
I have the pneumatic "lift-all" manual but it doesn't show how to mount the big cylinder. It only shows the parts for the cylinder itself.Also have parts manual that shows same thing. It has nothing about the mounts for the cylinder.
 
You must log in or register to reply here.

Similar threads

G
BN Pneumatic Lift-All
Replies
4
Views
361
Grumpydaniel
G
B
F-12 Power Lift Seals
Replies
6
Views
302
Charlie M
C
C
Power lift on F14 tractor
Replies
4
Views
307
BarnyardEngineering
BarnyardEngineering
glennster
1486 no hydraulics
Replies
4
Views
252
Mrfred54
M
P
275 lift arm and remote valve controls?
Replies
1
Views
154
bentrims
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top