Farmall H M Wide Front Bushing

Andy Motteberg · Jul 15, 2009

Hi all, on the early IH Farmall H & M wide fronts, there is a bushing or bushings in the center tube that seem to ben worn badly on a lot of them. Can these bushings and pin be purchased still? Where can they be purchased if they are available? Its worn pretty bad on Dad's H, and my Farmall M has a little wear in the bushings too.

Thanks

Wayne in MN · Jul 15, 2009

Andy: I bought the bushings at our local dealer here in Fergus Falls to install in my son's H with original widefront.
Part # 40084DA bushing, 2 required.
The pin (called a rod in parts book) is a retired #; have your local steel supplier cut one for you and just drill the pin hole needed.
Untitled URL Link

Andy Motteberg · Jul 15, 2009

Thanks Wayne! I would assume the bushings from the cast iron tube wide front and the steel tube fronts are the same, correct?

Thanks,
Andy

gene bender · Jul 16, 2009

When you remove the pin check as it will be a different size where the bushings go and samller in between. Thats the way the pins are on the A series. The bushings shouldnt be that hard to replace and anyone with some brass and a lathe coule make them but you should be able to get new ones from anyone who handles that sort of stuff.

Farmall H M Wide Front Bushing

Andy Motteberg

Well-known Member

Wayne in MN

Well-known Member

Andy Motteberg

Well-known Member

gene bender

Well-known Member

Similar threads