Behlen Power Stering Motor (Torque Generator)

Idaho Boy · Jul 2, 2009

How do I dissassemble a Behlen power steering motor (# 2041-18)? I have the bolts out but cannot separate the two shafts to get it apart?
How are they connected inside the unit? Are they pinned inside of a common sleeve? I am at a loss as to how the shafts come out! Any knowledge shared would be appreciated! Thanks in advance. Idaho Boy

f826 · Jul 3, 2009

i think they have pins to line up everything thats probly why you cant get them apart. also keep in mind that the gaskets in between each section are used like shims to keep tolerances.

D Slater · Jul 3, 2009

As other fellow posted dowel pins, there is another pin that comes out but the 2 halfs have to come apart so far first. Mark everything so its goes back the same. If you are just replacing o rings because of leaks at shaft, just remove one end at a time trying to keep rest of unit togeather.

Behlen Power Stering Motor (Torque Generator)

Idaho Boy

New User

f826

Member

D Slater

Well-known Member

Similar threads