504 international steering worn

Anonymous-0 · Jun 29, 2009

This row crop tractor occasionally shears the small roll pin in the assembly below the power steering unit below the steering wheel. To replace a 25 cent roll pin the steering wheel has to come off, remove all the screws holding the dash down, and with a bit of luck you can drive a new roll pin in with a long punch. Is there any way to permanently fix this?

MN Scott · Jun 29, 2009

I had a 504 that sheared that pin. Problem is the yoke and splines are both worn resulting in play that wears the pin. The pump motor shaft is unavaiable but you can still buy the yoke thru CNH. I put the new yoke on my 504 and it tightened it up enough to stop the pin from wearing and breaking.

504 international steering worn

Anonymous-0

Well-known Member

MN Scott

Well-known Member

Similar threads