(800) 853-2651
SHOP NOW

Super M slow 1st gear

I

IBleedIHRed

Member
I have found a Super M with the slow first gear.

Can I replace my 3rd, 4th, or 5th gear with this gear? I would like to keep my regular 1st and 2nd gear.

Any help would be greatly appreciated.

IBIHR
 
Not without a lot of machine work and I'm not sure it could even be done then. The low low first driving gear on the lower shaft is machined as part of the shaft, because the gear is too small to be bored and keyed on the shaft. The bottom shaft is machined at different diameter for each gear, so all the gear bores are different. There are a lot of parts to change in the transmission just to get the low low gear. Bottom shaft, The first and reverse sliding gear, the 2nd speed driving gear(since on the standard transmission, the 1/2nd driving gear are made as one piece), and the reverse idler gear, as well as several bushings.
 
If your question is can you take the third, fourth and fifth speed gears out of the transmission with the slow first gear and put them in yours? The second and third sliding gear along with fourth and fifth sliding gear will work. Third and fourth driving gears on counter shaft will work. Input shaft that has the teeth that 4 and 5 sliding gear locks on for fifth will work. So if your first and second drive gear along with first and reverse slider is good, the answer is yes.
If above is not the question, forget this post.
 
No it will not if you want to change speeds you will have to get new ones made and they will make anything you can afford 1st gear is for 1st gear and not any other gear. Better go to a machine shop that majes gears and tell them what you want. Do you need the adress of a place that will make em for ya get money ready. They make gears for the pullers so the gears would be strong enough for anything you will ever do.
 
You must log in or register to reply here.

Similar threads

W
Wiring for Super M With electronic ignition
Replies
10
Views
417
Janicholson
Janicholson
J
Farmall M gear change
Replies
6
Views
1K
560Dennis
560Dennis
W
5th Gear on an M
Replies
14
Views
648
busboy
B
John M
Perplexing Cub trans issue
Replies
12
Views
472
John M
John M
R
1984 JD 510 backhoe 8 Speed Transmission
Replies
4
Views
314
Roger_H
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top