(800) 853-2651
SHOP NOW

3 point stuck in up position

A

Anonymous-0

Well-known Member
Hello all. I have a problem with my IH444. I was moving some round bales and my 3 pioint went to the up position and now i can not get it move at all. The only way it will go down is after the tractor is off and it settles on its own but as soon as I start it back up it raises all the way up again. The adjusting lever is like it is locked in position, cant move it at all.Any ideas as to what might be the problem?
 
When the tractor is not running the position control lever will move back and forth so the linkage is not jammed, thanks for the suggestion though. It almost seems like the valve is stuck in the raise position but I really dont know for sure. After the tractor is off for a while and the 3 pt settles back down, if I close the flow diverter and start the tractor the 3 pt will not come up unless I open the flow diverter of course. I guess it is also worth mentioning that not only does it raise up but it keeps on wanting to raise,you can hear the pump going to relief so this is why I am thinking the valve is stuck.
 
You must log in or register to reply here.

Similar threads

O
Massey Ferguson 240 lift position control
Replies
2
Views
137
oldfartBill
O
C
3pt hitch goes up and down but will not maintain a position when stopped it goes back up
2
Replies
34
Views
1K
camfire
C
Randy G.
2940 rock shaft raise- lower operation
Replies
5
Views
181
Tx Jim
Tx Jim
T
Weak PTO on IH 300 Utility
Replies
4
Views
238
MARK ROBKE
M
W
link arms stuck
Replies
3
Views
439
RGMartin
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top