cub hydraulic pump

IH10020 · Jun 9, 2009

Hydraulic oil is getting into crankcase. Installed new seals in pump, did not help. Can a machine shop fix the problem short of buying a new expensive pump? Have thought of adding moter oil to pump and just draining it out & recycleing it. Thanks for the input.

Idaho Ron · Jun 9, 2009

Use a speedy sleeve. They slip over the shaft and that should take care of the problem. After you install the speedy sleeve put in a new o-ring. Ron

screwstick · Jun 9, 2009

Check out [b:9d81ce0c13]this post[/b:9d81ce0c13] from the Cub forum. I believe it will answer your question and give you a good option to think about.

Good luck

El Toro · Jun 10, 2009

You need to install a speedi-sleeve kit over that area where a groove is probably worn. Hal

cub hydraulic pump

IH10020

Member

Idaho Ron

Member

screwstick

Member

El Toro

Well-known Member

Similar threads