Removing carborator from my H

DuaneH · Jun 4, 2009

I'm needing help again... I can't get a wrench on the back nut on the carborator. I've tried a open end, boxed end and a swivil on a socket. I'm sure its something simple like holding my mouth right or my tongue right...but it's givin' me fits. Help!!

archie3 · Jun 4, 2009

I had to cut an open end wrench in half to get a carb off of a M one time.

GordoSD · Jun 4, 2009

Yep, That's the drill. FInd your oldest combination wrench, cut it down and then grind the box end smaller. Put some masking tape with "CARB" written on it when done.

Gordo

Nebraska Kirk · Jun 4, 2009

You will have to modify an open ended wrench by putting a 90 degree bend in it, then you can get the nut loose!

grotractor · Jun 4, 2009

I use the curved box end 1/2 and 9/16 inch
wrench.I think it came from Harbor Freight,but
Craftsman makes one also.
Don

Bob · Jun 4, 2009

You need a wrench of this type. The one I use is 90º at the end.

<img src = "http://webzoom.freewebs.com/mid-atlantictools/4pc%20Jumbo%20Angle%20Wrench%20Set.jpg">

Roy Ward · Jun 4, 2009

Turn a 4 inch boxend unside down.

DuaneH · Jun 8, 2009

Thank you all for your help......I got her taken care of.

Removing carborator from my H

DuaneH

New User

archie3

Member

GordoSD

Well-known Member

Nebraska Kirk

Well-known Member

grotractor

New User

Bob

Well-known Member

Roy Ward

Member

DuaneH

New User

Similar threads