Farmall C o-ring revisit

dougie94 · May 25, 2009

Sorry guys,I didn't give enough info.Yes I do have hydro fluid in my crankcase,so I posted a new pic and think I got it with your help this time.I think these are the o-ring"s" that need too be replaced??

SDE · May 25, 2009

No, The o-ring you need to replace is in the housing. Look at the gear with the longer shaft. The shaft will have some wear on it from the o-ring that is in the housing. A speedy sleeve and oring are about $30. The sleeve goes over the shaft and the oring goes in the housing.
Hope I helped you
Steve.

SDE · May 25, 2009

If you look at the schematic posted earlier, In the cover (5) you will see the groove for the o-ring to go into. I did not see the oring listed. Just pop out the old one and go to a parts store to get a new one or buy the speedy sleeve if the wear on the shaft is excessive.
Steve

dougie94 · May 25, 2009

Thank you,That did it,I see the ring now!My shaft has little 2 no wear.Thanks again

Jim Becker · May 25, 2009

The posted diagram shows a pump with a seal rather than an o-ring. The seal is number 4.

Farmall C o-ring revisit

dougie94

Member

SDE

Well-known Member

SDE

Well-known Member

dougie94

Member

Jim Becker

Well-known Member

Similar threads