(800) 853-2651
SHOP NOW

Farmall C oil pressure

J

Jim Isler

Member
I"m restoring a Super C. Sometime in the past the oil pressure line was redone with compression fittings. It seemed to work Ok, but the line was hopelessly twisted and wound around fittings.

Where can I get some of this tubing?
 
No. It's the line from the base of the oil filter that runs to the oil pressure guage. Thanks for your response.
 
If it is that small automotive type,there are kits available in most automotive parts houses for replacing the lines in cars.Even if different take the remains to a good helpful local auto parts guy.They should have what you need in stock.
 
You can probably get the copper tubing at Home Depot. Take a piece of the old tubing along so you get the correct size. It may be 1/4" od tubing. You can use compression fittings or double flare the tubing and use flare nuts on the tubing and change the exixting fittings to brass
45 degree flared fittings. Hal
 
Well. I see your replies that the oil pressure guage should be on the filter. My Super C has three holes in the instrument place: Ammeter, Oil Presure guage, and the light switch. The temp guage came to me mounted on top of the Touch Controls. Was the temp guage an aftermarket?
 
Ammeter, engine coolant temp gauge, and light switch in dash, hydraulic temp gauge (OPTIONAL) mounted over hyd levers, engine oil pressure gauge on filter base.
 
I think the Farmall A that I had sometime ago had the oil pressure gauge on the filter base and was easy to see. No tubing was needed. Hal
 
Originally it would have been the ammeter and the engine coolant temp gauge in the panel with the fuse and light switch. Oil presssure gauge would be mounted directly to the filter housing. The temp gauge above the T/C controls was for the temp of the hydraulic fluid.
 
You must log in or register to reply here.

Similar threads

L
Super A Oil Pressure
2 3
Replies
48
Views
2K
kshansen
K
D
1956 JD60 Oil Pressure Gauge and tubing
Replies
11
Views
593
wore out
wore out
4
Allis Chalmers oil filter
2
Replies
21
Views
1K
Jim.ME
J
S
Farmall C hydraulics
Replies
2
Views
234
Smarten_up
S
L
VAI Case - Only 2-3 PSI Oil Pressure
2
Replies
29
Views
1K
LeFeu
L
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top