Farmall B Single Bottom Plow Assembly

Anonymous-0 · May 17, 2009

I bought a '39 Farmall B last summer that came with a single bottom plow disassembled. I've looked at the three different pieces: one's the plow (that was the easy part, I think), one's an assembly with a hand control arm that appears to bolt onto the sides of the engine in front, and the third piece, also with a hand control arm, looks like it might somehow bolt in the general vicinity of the rear axle.
Any pictures, assembly directions, or encouragement greatly appreciated.

Anonymous-0 · May 17, 2009

You need a whole bunch of parts more than you described. A rockshaft assy that goes from fender to fender. A bunch of stuff fastening to the frone steering pedestal like a large u-shaped bar where the beam fastens to and the front lever hooks to raise and lower the depth of the plow. The other ls the lever mounts on the platfor to raise the plow out of the ground. So if you only have three pieces you are short a bunch of stuff and now way will it work untill you get everything. You better do the old thing and get a manual for that plow so you can figure out what all you are missing. Your plow is the B-192 so you can get the manual. I have the parts book and could run a copy but it wont tell how to install or set the tractor wheels for the correct tread for the width of the bottom you have.

Anonymous-0 · May 18, 2009

Gene,
Sorry if I didn't get into enough detail; the three things I mentioned might be better termed "sub-assemblies." I think it's all there (it's an act of faith; that's what the guy said who sold me the tractor).
I don't know a "rockshaft assy that goes from fender to fender." from a dipstick, but that might be the piece(s) that's not the plow and not the part you describe as " A bunch of stuff fastening to the front steering pedestal."
Maybe I could post some pictures. Would that help?

Anonymous-0 · May 18, 2009

Yes you could post pics but i still would get a manual very helpful when mounting and setting for operation. Yes there has to be a round bar that goes from fender to fender and some stuff mounting on that bar so the beam can hook to the bar. Then there is a heavy u-shaped piece with some more brackets that bolt to the front atra of the tractor its probably 2ft wide and heavy found with the ends being small. The lever that mounts to the platform by the fender is for lifting other lever bolts to the bell housing by the filter and that one controls the dept of the furrow. There is realy a bunck of parts not fastened to the levers as the lift lever just has a rod going under the seat to the lift assy that goes from fender to fender it is spring loaded.

Farmall B Single Bottom Plow Assembly

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

Similar threads