(800) 853-2651
SHOP NOW

MOWER IDENTIFICATION

P

PRTZMAN55

Member
Hello.
I recently purchased a 1967 int cub,
it came with a mower mounted on it.
It is supposed to be an Ih mower, but dont
know which one it is.
It mounts back at the rear drawbar and up under
the tractor, a chain lifts it via a rock shaft on the right side.
It is driven off the rear pto pully down to 2 idler pulleys to the center drive pulley or spindle. It has 3 blades and shoots out both sides.It measures 60"
Thanks
harry
 
HELLO AGAIN,
This uses a long belt from the pto to the center
spindle and one to each outer spindle .
Ive seem some in the photo section close to it but they are not identified.
 
Could be an IH/DANCO - these were available through IH dealerships. Take a look on he left side near where the discharge opening is - right on top should be a small metal data plate.

Another spot to look would be a belt cover on the PTO pulley...

Good Luck.
 
IH dealers around here used to sell woods mowers,and some were painted red,but they still were a woods mower,unless I misread the question he didnt say it had 2 belts,Still could be a woods
 
You must log in or register to reply here.

Similar threads

W
Cub sickle mower belt size and bracket mountin
Replies
8
Views
461
Oldiron29
O
R
Swing arm/Orchard Mower
Replies
16
Views
1K
r8f1k
R
4
B,C,CA mower
Replies
12
Views
1K
4wdtom
4
W
farmall cub c 22 mower question?
Replies
3
Views
933
BarnyardEngineering
BarnyardEngineering
G
Case 117 mower belt routing????
Replies
1
Views
589
Mark-Ia
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top