450 clutch adjustment

John4780 · May 10, 2009

I pulled the engine on my Farmall 450 gas before winter and had to replace the throw out bearing. I just put the enjine back into the tractor and hooked the clutch arm back up and now I can"t put the tractor in gear. I tried to adjust the clutch arm and that didn"t work. Did I maybe not get the throw out bearing set in the right place on the clutch shaft? I saw there were slots in the shaft but there were no wodruf keys in the shaft. Thanks

Anonymous-0 · May 10, 2009

You do indeed need the shaft keyed to the fork, it uses two thick flat washers that go into the slots in shaft and the two bolts that clamp fork to shaft go through the holes in washers and clamp fork to shaft.

Chris NW Ind · May 11, 2009

Sounds like you have to split it.... I know how feel. I replaced a piston on my Stihl years ago. Cold day, working outside. Got it all together, picked the saw up and noticed 2 little wrist pin clips hiding underneath. Had to tear completely down, again.

Chris B.

John4780 · May 11, 2009

Thanks for the help. I kinda figured something was missing. Those washers must have fell out when I slid the throw out bearing off the shaft. I saw the washers in amungst all the gunkie crap I scraped out of the bell housing. Thanks again.

450 clutch adjustment

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

John4780

New User

Anonymous-0

Well-known Member

Chris NW Ind

Member

John4780

New User

Similar threads