Reply:350 Governor-- to Jim Nicholsen

Clean John · May 10, 2009

THanks again Jim -I'm an old retired (maybe retarded Machinist-oper.?} All the linkage works fine now BUT was wondering about te slop in the weight pins --do you think these parts are hardened ?? before I tear it down and try to oversize and re-pin them? More of a hobby than a money and ordering problem. You always seem to come thru as well as the rest of the crew here.
My best to all of you THANKS!
John in Oregon

Anonymous-0 · May 11, 2009

I dont think they are hard, but I do not know for certain. The key is to not follow the egg of the worn hole, but where the old hole was. (tougher proposition without an EDM)
Make sure they have clearance on the pin, as much as .001, but more then .0006" JimN

Clean John · May 11, 2009

Thanks again my friend will bore them with an end mill. Will let you know Success/ or failure .
John

Reply:350 Governor-- to Jim Nicholsen

Clean John

Member

Anonymous-0

Well-known Member

Clean John

Member

Similar threads