(800) 853-2651
SHOP NOW

IH 1066 weak TA?

C

cgustafs

Member
This message is a reply to an archived post by mkirsch on March 10, 2008 at 16:26:38.
The original subject was "Re: IH 1066 weak TA?".

Is there a way to check mcv without flowtester (e.g. just check pressure?) I have the same problem in a 1086
 
Yes you can test the ta pressures without a flowrater, however, it requires two gauges, one in regulated pressure and other in lube circuit and you have to follow a definete procedure which will tell you if you have leakage internally, weak pump , personality of the regulator valve etc. If you could get you hands on a service manual for the 7 and 806 , can't remember Gss number off hand, it will lead you through the procedure. Later manuals will too but I always felt the original one did the best job of explaining all the works.
 
Are you refering to factory service manual or the I&T manual? I have the latter for 1086 but don't recall seeing it there. Thanks
 
When ya use the two gauge check you MUST HAVE THE TEST SPOOL To install in that port then and only then can ya use the two gauges . one gauge in the bottom pressure reg will tell ya the system pressure And on a 1066 245-265 will work fine and nothing less then 220 I prefer the 265 BUt that is just me . If Pete and i knew what is wrong then maybe we could head ya in the wright direction better. Between Pete myself and one other guy we are the guys that fixed these tractor everyday for a living . And vary few have a flow rater I have one But i made my living fixing I H tractors at my own shop . Pete and Owen worked for dealers and the dealership spent the BIG BUCKS for that flow rater . I lucked out and bought out 90% of the shop tools from a closed up old I H dealer . BUt if you want a flow rater and a good one then you can get a reman OTC for around 3700 bucks .
 
You must log in or register to reply here.

Similar threads

G
IH D282 Precups
Replies
5
Views
346
gnoah
G
V
656 brake shims
Replies
1
Views
253
used red MN
U
T
Farmall C charging system will not work
Replies
1
Views
297
used red MN
U
1
Anyone Own a Hydra Creeper
Replies
0
Views
232
1185Time
1
A
VC water pump
Replies
0
Views
229
a07589
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top