(800) 853-2651
SHOP NOW

SH throttle shaft question

A

Anonymous-0

Well-known Member
I'm putting the carb/governor linkage back together. The throttle shaft housing has a new oilite and I restored the key that fits in the carb. All is totally loose. When I bolt the housing up to the carb I get some drag on the throttle shaft. It's not alot but is any acceptable?? I've done a bunch of C113/123's but this is my first H.
 
The bowl, or body, might be warped a bit. flat sanding might work. Do not over torque the fasteners. JimN
 
Check that the front of throttle tube is free to move to where it wants to end up after mounting to carburetor.(not binding in governor housing and cocking it) You may have a height problem that results from material removed from head surface, or poor fitting manifold. Some aftermarket ones used to be bad on that. Also tube may not center the throttle shaft exact in center on carb end and be cocked a little in new bushing. Sometimes spining tube 180 degrees will help. Also try stopping just short of tightening the 2 throttle shaft screws all the way and move end of tube to see if there is a place shaft is more free. If so you may have to give a little more clearance at bushing.
 
You must log in or register to reply here.

Similar threads

C
Ford LT11 with Briggs question
Replies
2
Views
170
CBenedict1024
C
C
Governor Troubleshooting
Replies
9
Views
1K
Colin King
C
O
Hd800 throttle linkage
Replies
1
Views
469
VicS
V
O
Water pump shaft play
Replies
1
Views
421
MMDEL
M
B
2606 issues after rebuild
2
Replies
31
Views
693
bc
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top