Stephen McCoy
Member
I am try to find information about a lift valve I saw on a H with mounted cultivators. The valve mounted in place of the single hydraulic control rod and had a gate system in a similar pattern to a typical transmission shift patter like this l-l-l.
Apparently when the control lever was in the center section both cultivators would be raised or lowered at the same time. When the lever was in the left gate only the left side cultivators would be adjusted and the same for the right side cultivators when the lever was in the right gate.
Does anyone know if this was an IHC part or maybe an M&W? Was this common or rare? Are reproduction units available?
I wasn't able to get a picture of this since I didn't have my camera with me at the time so if someone else could post a pic that would be greatly appreciated.
Apparently when the control lever was in the center section both cultivators would be raised or lowered at the same time. When the lever was in the left gate only the left side cultivators would be adjusted and the same for the right side cultivators when the lever was in the right gate.
Does anyone know if this was an IHC part or maybe an M&W? Was this common or rare? Are reproduction units available?
I wasn't able to get a picture of this since I didn't have my camera with me at the time so if someone else could post a pic that would be greatly appreciated.