(800) 853-2651
SHOP NOW

RustyFarmall Range trans cover

T

TGIN

Well-known Member
I need a new aftermarket range trans cover for 706 . Can you get one ? Cant find anyone to bush mine .
 
Where are you at I can get it done rather cheaply if you can get the lid here. I"m in Owosso MI or call me 989 413 5684. I can also bore it with a drill bit in the drill press then fit the bushing to the hole. Well if you want that to shift like new again just change it over to a 56 series shifter did it on an 806 boy what an improvement.
To change it over is not that big of a job either.
 
The advantage of going with a rebuilt cover from a from a reputable rebuilder is that they machine the hole for the bushing in the correct location rather than just using a drill bit and following the worn hole. When done properly the rebuilt cover is better than new. The bushing is steel rather than cast and, depending on the application, may have more wear surface than the original hole.
 
I m in S.E. IN. and I ve asked around but hav nt found anyone that has done it before and I dont want to be anybodys ginnypig ! I d rather just buy one .
 
You must log in or register to reply here.

Similar threads

F
Will 560 front end fit on 706 ?
Replies
6
Views
344
used red MN
U
W
trans hard to shift from high to low range
Replies
13
Views
666
John Schoenauer
J
P
Cub torque tube renoval, do I need to drain trans?
Replies
19
Views
580
grandpa Love
grandpa Love
WELDINGWIZARD
  • Question
WD45 trans/ rear end question
Replies
8
Views
615
WELDINGWIZARD
WELDINGWIZARD
F
YT parts section. Is this also for the 706 ?
Replies
8
Views
635
FinallyFarming
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top