farmall super c hydraulics

mitchfarmallsuperc · Apr 20, 2009

i was wondering,if i get a loader for my farmall super c where do i hoke up the hydraulic hoses on the tractor it would be grate if i had a picture or diagram of some sort thanks

CNKS · Apr 20, 2009

You need a bypass block that goes under the manifold on the reservoir, you will also need a spool valve to mount on the light bar. Available from www.saginawcountytractor.com-810-638-5787-can't order online. Others will have other sources.

georgeky · Apr 20, 2009

Or an original Farmall valve for it. They sell on ebay fairly often. Email me and I will show you every thing you need for the original set up. If you can't find one CNKS has the right plan.

CNKS · Apr 20, 2009

I wouldn't mind having an original, provided the linkage is with it. The light bar spool valve on my C is somewhat clutzy looking, the lever would be better but it works fine. I have another C to do that way, might try to find one then, provided it isn't all beat up. I've only ordered once from ebay, not tractor parts, but a TV antenna to mount on a satellite dish for local stations, it did not work. That's a 100% failure rate, so I'm have to know what I am getting.

mitchfarmallsuperc · Apr 20, 2009

how much would that hole thing coast?

mitchfarmallsuperc · Apr 21, 2009

(quoted from post at 17:49:09 04/20/09) Or an original Farmall valve for it. They sell on ebay fairly often. Email me and I will show you every thing you need for the original set up. If you can't find one CNKS has the right plan.

a hi how much would that coast?and where does it hoke up ?

do the loaders for the tractor have like the control rod so all i have to do is hoke up the lines to the tractor? thks

mitchfarmallsuperc · Apr 21, 2009

so how do i know if my farmall super c has that bypass block and i also did not see it on that site u gave me
and do u have an idea how much the bypass block and vale would coast me?

mkirsch · Apr 21, 2009

Mitch, buddy, calm down a little. Take a breath. Speak in complete sentences. We'll get through this.

Almost 100% chance you do NOT have a bypass block. It would be obvious. There would be a 3/4" thick solid steel block between the hydraulic lines from the engine and the hydraulic unit under the gas tank. There would be hoses coming off this solid steel block going to a hydraulic valve.

Most Cs do not have this block.

The block will cost about $40 from ebay. If you can't find it on Saginaw's site, you just didn't look hard enough. It's there, but more expensive than ebay.

The valve will cost $100 to $200 depending on what you get. If you want a loader that just goes up and down, $100. If you want a hydraulic dump bucket you need to get a remote valve with two controls, $200.

You will also need hoses and fittings to hook it all up. Another $50-$100.

georgeky · Apr 21, 2009

Send me an email and I will send pics of the complete setup both on and off the tractor. Will likely cost 200+ dollars for the original set up.

email is open.

farmall super c hydraulics

mitchfarmallsuperc

New User

CNKS

Well-known Member

georgeky

Well-known Member

CNKS

Well-known Member

mitchfarmallsuperc

New User

mitchfarmallsuperc

New User

mitchfarmallsuperc

New User

mkirsch

Well-known Member

georgeky

Well-known Member

Similar threads