(800) 853-2651
SHOP NOW

Farmall H 4/5 gear removal

A

Anonymous-0

Well-known Member
Hi guys I have a 42 H that will jump out of road gear. I have the top transmission cover off, and the inside teeth of the 4/5 slider gear are worn pretty good, and the gear needs replacing. How do i go about getting this gear off the splined shaft? Thanks in advance, all help is greatly appreciated.
 
You have to remove the lift all and then the main drive shaft coupling and the clutch shaft. When all that is out, you unbolt the bearing/holder assembly from the front of the transmission housing. The assembly, including the bearing holder, seal holder and the transmission input shaft will then slide out the front of the transmission. I can't recall if the gear will slide off over the pinion bearing or not, but I think you will have to remove the retainer bolt for the pinion bearing, remove the pinion bearing and then the 4/5 slider gear can be taken off and replaced. While you are in there, make sure to check the transmission input bearings for play and replace if needed and you might as well put a new shaft seal in as well.
 
Thanks alot Haas, I appreciate the detailed description...if I have any more questions I will be sure to ask.
 
You must log in or register to reply here.

Similar threads

tn terry t
H road gear
Replies
4
Views
289
Janicholson
Janicholson
J
Farmall H front end wobble
Replies
2
Views
315
JMFarmallH
J
Ellis Kinney
update on PTO project
Replies
6
Views
281
300guy
3
M
Farmall H Water Jacket Questions
Replies
5
Views
562
rcmedic
R
D
Pto shifter stop replaced, now the assembly wont reseat
Replies
1
Views
130
mhb@ufe
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top